2.2 Adjusting the handlebars:
6 mm Allen Key
For your comfort, the position of your handlebars must be at the same level as the height of your saddle or a
bit higher according to your comfort. Unscrew the Allen screw and adjust your handlebars to the desired
height.
Do the same with the second screw to set the angle of tour handlebars, after making your adjustments,
tighten the screws vigorously, with a max. tightening torque of 10 Nm.
THE STEM MUST NOT COME OUT OF THE HEAD TUBE BEYOND THE ENGRAVED MARKINGS (VERTICAL BARS AND
THE INSCRIPTION MINIMUM INSERTION).
After adjusting the angle, tighten the screw by turning it clockwise (max. tightening torque: 10 Nm).
To Next Page
Loading...