9
AutoBatch
“AutoBatch” or “automatic batch” allows you to batch count with automated features. In the Autobatch mode you can
program the number of sheets you would like to process in a set, the total number of sets and the delay between each
set. For example: you can program 10 sheets to be pulled to create a set, then program 100 sets to be processed with a
3-second time delay between each set.
1. To enter AutoBatch mode, highlight “AutoBatch”
on the “Batch Counting” screen using the “ ”
buttons. Press the “ ” button to enter.
2.
“Sheets” is highlighted. Press the “ ” buttons to
set the number of sheets for each set. Press the “ ”
button to enter your selection and advance to the next
screen.
3.
“Sets” is highlighted. Press the “ ” buttons to
select the number of sets. Press the “ ” button to
enter your selection and advance to the next screen.
4.
“Delay” is highlighted. Press the “ ” buttons to
set the time delay between each set. Press the
“ ” button to enter your selection and advance to the
next screen.
5.
Press the “ ” button to begin folding. The “ ”
button can be pressed to edit the settings. Press the
“C” button to exit to the main screen.
NOTE: If a fault occurs during a set the set will be
completed when the fault is reset.
© 2009 Neopost USA Inc. All rights reserved.
To Next Page
Loading...
Need help?
General
