Neostar Electronics M945234 - General Safety Precautions; Safety Guidelines; Parts Identification; Control Panel Components

To Next Page

To Previous Page

Scotts Ltd. Cotswold House, 1 Crompton Road, Groundwell, Wiltshire. SN25 5AW

Enquiries: 0344 482 1414

Thank you for purchasing the 3.5 & 5.0 litre hot water dispenser. We hope that you will be

happy with your product. Please read the following instructions prior to use and retain for

reference.

General Safety Precautions:

 This item is designed for indoor, domestic use only.

 Always attach the power cord o the appliance BEFORE you plug it into the mains

 To disconnect the appliance, always switch off the main switch before removing the cord.

 Check that the voltage indicated on the rating plate corresponds with that of the local supply

before connection.

 This hot water dispenser is not intended for use by persons (including children) with reduced

physical, sensory or mental capabilities or lack of experience or knowledge. They should be

given supervision and instruction in the use of the appliance by a person responsible for their

safety.

 Children should be supervised to ensure that they do not play with the appliance.

 Close supervision is necessary when operating the appliance near children.

 Ensure the electrical cord does not hang over the edge of the work surface. Keep the cord away

from sharp edges or heat that could cause damage.

 If the electrical cord is damaged, a qualified engineer must replace it in order to avoid a hazard.

 Do not attempt to operate the hot water dispenser with a damaged electrical cord.

 Always place the hot water dispenser on a flat and stable surface. When moving the appliance

always be aware not to touch hot surfaces.

 Do not immerse the hot water dispenser in water or any other liquids.

 Use of accessories or equipment not supplied by the manufacturer may cause damage or

malfunction of your appliance, or could result in injuries.

 The appliance contains no user serviceable parts. All repairs should only be carried out by a

qualified engineer. Improper repairs may place the user at risk of harm and will invalidate any

warranty.

 Do not dispense water until the hot water dispenser has reached the temperature set.

PARTS IDENTIFICATION

Function panel

Boil indicator

2. Keep Warm indicator

3. Temp Set button

4. Timer button

5. Re-boil button

6. Dispense button

7. Unlock indicator

8. Unlock button