Neostar Electronics M945234 - Operating Instructions; Opening the Top Lid; Filling and Re-filling the Dispenser

3
Scotts Ltd. Cotswold House, 1 Crompton Road, Groundwell, Wiltshire. SN25 5AW
Enquiries: 0344 482 1414
HOW TO USE YOUR HOT WATER DISPENSER
 OPENING THE TOP LID:
o Push down the front edge of the TOP COVER LOCK FLAP located on the lid.
o Lift the flap by pulling upwards to open the top cover.
Water may still be hot and steam may escape
–
please take care.
 FILLING AND RE-FILLING
o Open the Top Cover as per the above instruction, then using another container, pour
water into the Inner pot until the FULL mark is reached. DO NOT over fill as hot
water may splash out during boiling.
o Close top cover, ensure lid is secured by pressing firmly down till “click” sound is
heard.
o DO NOT switch on until after the water boiler has been filled with water.
o For best results, we would recommend using filtered water in the hot water
dispenser to reduce possible lime-scale build up.
1.
Water P
ump Lid
2. Upper Lid
3. Top Cover Lock
Flap
4. Control panel
5. Middle ring
6. Outer body
7. Water Level
Gauge
8. Power Inlet
9. Rotating Base
10. Power Cord
Product Parts