Neoway N27 EVB - 3 Power and Connection; Power Supply; Communication Connection; M5 X0-PWR Board

N27 EVK User Guide
Chapter 3 Power and Connection
Copyright © Neoway Technology Co., Ltd
4
3 Power and Connection
Power is supplied for the N27 EVB only through external power cables. The N27 EVK provides one
M5X0-PWR cable and one Micro-USB cable for data communication.
3.1 Power Supply
The N27 EVB provides solder pads for external power cables, as shown in Figure 3-2. The input voltage
ranges from 3.1V to 4.3V and a 3.6V regulated power source is recommended.
Figure 3-1 Power pads
The power source supplies voltage to the module directly in this manner. Do NOT connect the pads reversely or
use a power source exceeding the requirements. Otherwise, the module will be burned and cannot be repaired.
3.2 Communication Connection
3.2.1 M5X0-PWR Board
M5X0-PWR board is developed on PL2303 chipset by Neoway and used to convert USB to UART. You
can also choose another USB-to-UART cable/board based on FT2232, CP210X, and other chipsets.