NGP\00329 Rev. C 23-06-2006 Evolution Series - XPAND 45
synchronous digital hierarchy (SDH).
ITU-T Rec. G.826 (02/1999) Error performance parameters and objectives for international, constant bit rate digital
paths at or above the primary rate
ITU-T Rec. G.828 (03/2000) Error performance parameters and objectives for international, constant bit rate
synchronous digital paths
ITU-T Rec. G.921 (11/1988) Digital Sections based on the 2048 kbit/s hierarchy.
ITU-T Rec. G.957 (06/1999) Optical interfaces for equipments and systems relating to the synchronous digital
hierarchy
ITU-T Rec. G.958 (11/1994) Digital line systems based on the synchronous digital hierarchy for use on optical fiber
cable
ETSI TR 101 036-1 V1.3.1 (2002-
08)
Fixed Radio Systems; Point-to-point equipment; Generic wordings for standards on
digital radio systems characteristics; Part 1: General aspects and point-to-point
equipment parameters
CEPT/ERC Rec. 74-01 E (2002-10)
Spurious Emissions
CEPT/ERC Rec 14-01 E (1996-08) Radio-frequency channel arrangements for high capacity analogue and digital radio-
relay systems operating in the band 5925 MHz – 6425 MHz
CEPT/ERC Rec 14-02 E (1996-08) Radio-frequency channel arrangements for medium and high capacity digital radio-
relay systems operating in the band 6425 MHz – 7125 MHz
CEPT/ECC Rec 02-06 (2002-08) Preferred channel arrangement for digital fixed service systems operating in the
frequency range 7125-8500 MHz
CEPT/ERC Rec. 12-06 E (1996-12)
Harmonised radio frequency channel arrangements for digital terrestrial fixed systems
operating in the band 10.7 – 11.7 GHz
CEPT /ERC/REC 12-02 (1996-08) Harmonised radio frequency channel arrangements for analogue and digital terrestrial
fixed systems operating in the band 12.75 GHz to 13.25 GHz
CEPT/ERC/REC 12-07 E (1996-08)
Harmonised radio frequency channel arrangements for digital terrestrial fixed systems
operating in the bands 14.5 - 14.62 GHz paired with 15.23 - 15.35 GHz
CEPT/ERC/REC 12-03 (1996-08) Harmonised radio frequency channel arrangements for digital terrestrial fixed systems
operating in the band 17.7 GHz to 19.7 GHz
CEPT T/R 13-02 (1994-02) Preferred channel arrangements for fixed services in the range 22.0-29.5 GHz
IEC 297-2
Dimensions of mechanical structures of the 486.6mm (19in) series: Cabinet and pitches
of the rack structures”.
IEC 297-3 Dimensions of mechanical structures of the 486.6mm (19in) series: Sub-rack and
associated plug in units”.
IEC 60169-16, Ed. 1.0 Radio-frequency connectors. Part 16: R.F. coaxial connectors with inner diameter of
outer conductor 7 mm (0.276 in) with screw coupling - Characteristic impedance 50
ohms (75 ohms)
IEC 60169-29, Ed. 1.0 Radio-frequency connectors - Part 29: Miniature r.f. coaxial connectors with screw-,
push-pull and snap-on coupling or slide-in rack and panel applications; Characteristic
impedance 50 ohms
IEC 60603-7 (1996) Connectors for electronic equipment - Part 7-1: Detail specification for 8-way, shielded
free and fixed connectors with common mating features, with assessed quality
IEC 60835-2-8 (1993-05) Methods of measurement for equipment used in digital microwave radio transmission
systems - Measurements on terrestrial radio-relay systems - Adaptive equalizer.
IEEE 802.3 Carrier Sense Multiple Access with Collision Detection
To Next Page
Loading...