10
12. SAFETY GUIDELINES
Any rotating or moving parts of the laminator and parts under electrical power may
cause severe or even fatal injuries. Installation, wiring, putting into service as well as
maintenance and repairs may be performed by qualified and trained personnel only.
•
••
• The laminator may only be operated only by persons older than 18 years of age, mentally
and physically fit, duly instructed (with their knowledge verified) and authorised to operate
the laminator.
•
••
• More demanding repairs and any work on the laminator’s electrical installation may be
performed only by an appropriately qualified person or by the manufacturer.
•
••
• Laminator operators and maintenance workers must be well acquainted with these User
Instructions
•
••
• Any adjustments, maintenance and cleaning of the laminator must be performed while the
laminator is idle, the main switches turned off and the machine disconnected from power
mains.
•
••
• Never start the laminator with covers off.
•
••
• Never touch any moving parts of the laminator
•
••
• Keep all safety pictograms attached to the laminator legible.
•
••
• Work only under good lighting conditions or arrange for adequate artificial lights.
•
••
• Before starting to work with the laminator, always check and make sure that all safety
devices of the laminator are installed and that they function faultlessly.
•
••
• Never work with the laminator when you feel tired.
•
••
• Let any damaged parts of the laminator be replaced by an authorised maintenance worker.
Only original spare parts may be used for replacement.
•
••
• If the laminator starts to strongly vibrate, becomes increasingly noisy or shows any other
unusual symptoms, turn the laminator off and report the problem to your supervisor.
•
••
• Fasten any loose parts of your clothing (e.g. a tie) or long hair so that they cannot get caught
between the laminator’s rollers.
•
••
• When working with laminator, make sure you are standing firmly on the ground.
•
••
• After switching the laminator on and starting the work rollers, be doubly cautious.
•
••
• If while working with the laminator you notice any damaged insulation, smell that something
is burning, notice smoke or hear loud rumbling noise, the machine jerks after being started,
some parts of the laminator’s electrical equipment have overheated, sparks are coming out
or you can feel tingle from electricity, turn the electrical equipment / the laminator off
immediately and report the problem to your supervisor.
•
••
• If such danger or a danger to your fingers occurs, turn the laminator off by pressing one of
the safety Emergency STOP buttons.
To Next Page
Loading...