12
15. DISPOSING OF THE PRODUCT OR ITS PARTS
• When discarding the laminator after it has reached the end of its service life, abide by
relevant environmental protection rules and use recycling options where available.
• Separate plastic parts and offer them for recycling.
• Separate metal parts and sort them out by type and offer as scrap metal.
16. MAINTENANCE AND REPAIRS
MAINTENANCE
1. Neschen laminators are of a robust and sturdy construction. They require minimum
servicing. To guarantee problem-free use and long life, abide by the following principles:
2. Use isopropyl alcohol for cleaning roller surfaces. For cleaning other surfaces use a diluted
detergent solution and a damp soft cloth. Never use solvents or abrasive products.
3. Before starting to clean or maintain the laminator, always disconnect it from power mains.
4. Protect the roller surfaces against damage by sharp objects (cutting blade, scissors, sharp
plate edges, penetration of hard uneven objects, work tools, etc.), and against dust. If you
protect the roller surfaces from damage, the laminator will give you many years of problem-
free service.
5. Do not leave the rollers unnecessarily pushed against each other to prevent impressions
from developing.
REPAIRS
Before starting any repairs, always disconnect the laminator from power mains.
1. Blown fuse – replacing fuses:
The laminator has fuses for three circuits: 2 × 9V and 1 × 230V. The fuses are situated on the
laminator’s Main Board in the right sidewall and on the heating plate in the left sidewall.
Replace any blown fuses.
If you encounter a more serious problem, contact the vendor!
A list of spare parts supplied together with the machine:
1. Fuse T2L250V, one unit;
2. Fuse T500mAL250V, 2 units.
17. WARRANTY TERMS AND CONDITIONS
To Next Page
Loading...