Nespresso 231 / NP200 User Manual

EN
.
42
9. MAINTENANCE
9.1. Momento Coee / Momento Coee & Coee
9.1.1. Setting the water filtration system
filter
water filter installation
would you like to install a water
filter?
yes
no
setup menu
set water hardness
set water filter installation
Alternatively, an external filtration
system can be installed by a
Nespresso service partner if the
machine is installed with a direct
water connection.
i
The machine can be installed without
water filtration. Refer to the descaling
table for frequency. Follow the instruc-
tions on the screen to set the water
filter.
If the machine is already installed,
you can go to the setup menu > “set
water filter installation” to change the
seing.
9.1.2. Change the water filter
filter
The water tank should be cleaned every time the filter is changed. Alternatively, when the “filter” symbol appears in red,
you can start the water filter change procedure by entering the maintenance menu. Select “change the internal filter”
and follow the instructions. There are 3 possible options to set the water hardness: A, B, C. Refer to “Descaling intervals
with / without internal filter” on page 43.
To complete the new water filter installation, the machine will automatically perform a rinsing cycle of approximately
0.5 litres through the outlets, to ensure optimal performance. Therefore, place a container with enough capacity under
the outlets.
insert capsule
hot water
filter
1
water filter installation
2
3
When the “filter” symbol appears
in red the internal filter should be
changed. Tap on the red filter symbol.
Follow the instructions on the screen
to set the water hardness on both the
machine and the new water filter.
Once the water hardness is set,
remove the water tanks and its lids.
4
5
6
Remove the old water filter. Clean
the water tank and rinse it with fresh
drinking water.
Fill a receptacle with fresh drinking
water. Immerse the new water filter
completely and squeeze it several
times until all air bubbles have been
removed.
Insert the new water filter. Fill the
water tanks with fresh drinking water
and aach the lids again. Insert the
water tanks back into the machine.
9.1.3. Descaling
The procedure will last about 15 minutes. For descaling, use Nespresso liquid descaler. Never use vinegar. Alternatively,
the maintenance menu can be entered to start the descaling procedure.
descale
To secure machine life time and
consistent coee quality day aer
day, the use of the machine will
be blocked aer 30 days of the
descaling alerts.
i
insert capsule
hot water
descale
1
min
max
Material needed:
Prepare the following items to
complete the descaling process:
– cleaning tank
– waste water container
– 2 bags of Nespresso liquid descaler
(4 bags for the Momento
Coee & Coee)
– 1 l of water (2 l for the Momento
Coee & Coee)
When the “descale” symbol appears in
red, the machine should be descaled.
Tap on the red descaling symbol and
follow the instructions on the screen.
The water tank shows dierent marks.
Refer to the descaling mark when
descaling the coee system. If the ma-
chine is equipped with water filters,
always remove them before descaling.

Nespresso 231 / NP200 Specifications

General

Brand	Nespresso
Model	231 / NP200
Operation	Automatic
Pump Pressure	19 bar
Product Type	Espresso Machine
Cup Size	Espresso, Lungo
Heating Time	25 seconds
Power	1260 watts