7. Run the power cable through the wall
Go inside your home and slip the wall
grommet over the adapter cable.
Then run the cable through the hole to the
outside.
Important: Don’t plug in the adapter yet.
You might damage it if the wire ends touch
each other. Keep it unplugged until you
finish installation.
8. Connect the adapter wires to Hello
● It doesn’t matter which terminal you
connect a wire to.
● Make sure the screws are snug and that
the wires point down as shown. This is so
excess wire can be tucked back into the
wall, letting Hello properly connect to the
wall plate.
To Next Page
Loading...
