nest Thermostat - Run Power to the Heat Link

Junction box
Boiler
Heat Link
Install Heat Link
4. Run power to the Heat Link
Use a cable to connect the L (live) and
N(neutral) connectors on the Heat Link
to the L and N connectors on the boiler
or junction box. This will power the
HeatLink.
If existing controls operate at mains
voltage, you can add a jumper cable
between live and common. The jumper
cable should be 0.75mm
2
and 55mm
long (with 8mm of exposed cable at
eachend).
WARNING:
DO NOT SKIP
It’s important to install the Heat
Link before the Nest Thermostat.
Otherwise, high voltage current
will irreparably damage the
Nest Thermostat.
12