nest Thermostat - Attach the Heat Link; Configure the Programmer

attach sticker
8. Configure the programmer
If there’s a programmer that controls
hot water and heating, setthe
heating controls to ALWAYSON. If the
programmer onlycontrols heating,
then remove it. The HeatLink will
control heating initsplace.
TIP: Put this sticker on the
programmer to remind
homeowners not to adjust it.
7. Attach the Heat Link
Use the included screws to attach the
HeatLink to a wall near the boiler or
junction box, making sure to leave
30cmof space on all sides. When you’re
done, put the Heat Link cover back on.
Check page 11 for placement info.
Install Heat Link
Installation step-by-step
REPLACE A THERMOSTAT
15