Netafim Arkal 2” Spin-Klin Compact Stand Alone Filter User Manual

2” Spin Klin
Shipment and transporting
 Shipping and transporting the filter must be done in a safe and stable manner and in accordance with the relevant
standards and regulations.
 For shipping, lifting and positioning the filter, use only approved lifting equipment and authorized employees and
contractors.
Electricity
 Electric wiring should be performed by an authorized electrician only, using standardized and approved components.
 The system must be installed with suitable electrical earthing that would prevent any electrostatic discharge from the
system.
 Install a lockable main power cut-off switch close to the control panel.
 If due to site constraints, the control panel is installed without a clear line-of sight of the filter, an additional lockable
power disconnect cut-off switch should be installed near each filter unit.
 Installation of the filter should be performed so as to avoid direct water splashing on the electrical components or on
the control panel.
Pneumatics
 Install a lockable main cut-off switch, featured with a pressure release mechanism, on the compressed air supply line
close to the control panel.
 If the control panel is installed far away and there is no eye contact with the filter, a lockable compressed air cut-off
switch, featured with a pressure release mechanism, should be installed near each filter unit.
 The user should make sure that the compressed air supplied to the filter never exceeds the maximum designated
pressure for this filter. An air-pressure reduction valve should be installed on the compressed air supply line upstream of
the filter’s pneumatic inlet port.
Hydraulics
 Extra safety devices should be installed on hot water applications to avoid skin burn danger.
 The user should install a manual Water Cut-off Valve next to the filter’s inlet port.
 In cases where the downstream piping network downstream of the filter is pressurized an additional manual Water Cut-
off Valve should be installed next to the filter outlet port.
 The user should make sure that the system includes a Pressure Release / Drainage Valve to enable release of residual
pressure prior to any maintenance procedure performed on the filter.
 The user should make sure that the filter is never exposed to water pressure exceeding the maximum designated
pressure for this filter, if needed a Pressure Reduction Valve should be installed upstream of the filter’s water inlet port.
 Please note that the maximum working pressure indicated at the filter’s specifications table includes the pressure
caused by fluid hammer and pressure surge effects.
Civil Engineering
 Make sure that the filter installation is done by the manufacturer-qualified technicians.
 Make sure that any civil engineering work at the installation site such as construction, lifting, welding, etc. is done by
qualified workers / technicians / contractors and in accordance with the relevant local standards.
 While using lifting equipment, make sure that the filter or the lifted part is chained securely and in
a safe manner.
 Do not leave lifted equipment if there is no necessity. Avoid working below lifted equipment.
 Wear a safety helmet while using lifting equipment.
 Make sure that the flooring is sloped to for drainage and to avoid accumulation of liquids.

Netafim Arkal 2” Spin-Klin Compact Stand Alone Filter Specifications

General

Brand	Netafim
Model	Arkal 2” Spin-Klin Compact Stand Alone Filter
Category	Water Filtration Systems
Language	English