2” Spin Klin
1. Introduction
General
We congratulate you for purchasing the 2" Spin Klin compact filter. Our filters are easy to install, use and service; they
require no special skills to operate. For operation and maintenance of this filter, please follow the instructions in this
manual. This 2” Spin Klin filter is an automatic self-cleaning filter designed for non-hazardous liquids only and for
operation within the pressure framework described in the specifications table.
2. Safety Instructions
General Safety Instructions
The manufacturer filtration products always operate as components in a larger system. It is essential for the system
designers, installers and operators to comply with all the relevant safety standards.
Prior to installation, operation, maintenance or any other type of action carried out on the filter, read carefully the
installation and operation instructions.
During installation, operation or maintenance of the filter all conventional safety instructions should be observed in
order to avoid danger to the workers, the public or to property in the vicinity.
The system has to be used for non-hazardous liquids only!
Please note: The filter enters into a flushing mode automatically, without any early warning.
No change or modification to the equipment is permitted without a written notification given by the manufacturer or by
its representative, on the manufacturer’s behalf.
Always observe standard safety instructions and good engineering practices whilst working in the filter’s vicinity.
Use the filter only for its intended use as designed by the manufacturer, any misuse of the filter may lead to undesired
damage and may affect your warranty coverage. Please consult with the manufacturer prior to any non-regular use of
this equipment.
System's cleaning and maintenance shall be carried out only when explosive atmosphere is not present!
Installation
General
Install the filter according to the detailed Installation Instructions provided with the filter by the manufacturer and
according to the description given in this manual.
Make sure to leave enough clearance, side and top, so as to enable easy access for future treatments and safe
maintenance operations.
The user should arrange suitable lighting at the area of the filter to enable good visibility and safe maintenance.
The user should arrange suitable platforms and safety barriers to enable easy and safe access to the filter without
climbing on pipes and other equipment. The user should verify that any platform, barrier, ladder or other such
equipment is built, installed and used in accordance with the relevant local authorized standards.
Check and re-tighten all bolts during commissioning and after the first week of operation.
Use only appropriate standard tools and equipment operated by qualified operators when installing, operating and
maintaining the filter.
When installation is required in hazardous environment sites, underground or high above ground, make sure that the
site design and the auxiliary equipment are appropriate and that installation procedures are carried out in accordance
with the relevant standards and regulations.
Ensure walking areas about the installation are slip free when wet.
To Next Page
Loading...
Need help?
General
