FLEXNET BARB CONNECTOR ASSEMBLY INSTRUCTIONS
3
Branching a ½” thread
1.
Use a 18-19 mm (3/4") drill-bit to drill a hole at the designated place (
Fig. 13
).
2.
Use a BSP/NPT 1/2" tap to prepare the thread (
Fig. 14
).
3.
Connect the relevant accessory (apply Teflon tape) (
Fig. 15
).
If needed, retighten under water pressure.
Fig. 13 Fig. 14 Fig. 15
Netafim Tapping kits: Cat No.
45000-003162 and 45000-003185.
Other Possible uses:
Branching connector Air vent.
To Next Page
Loading...