2. Verify that the hot-added shelf is cabled correctly.
If any cabling errors are generated, follow the corrective actions provided.
NetApp Downloads: Config Advisor
3. If you disabled automatic drive assignment as part of the preparation for this procedure, you need to
manually assign drive ownership and then reenable automatic drive assignment, if needed.
Otherwise, you are done with this procedure.
Complete the hot-add
Cable a hot-add shelf for an AFF A700 or ASA A700HA pair
How you cable an NS224 drive shelf in an AFF A700 or ASA A700HA pair, depends on
the number of shelves you are hot-adding and the number of RoCE capable port sets
(one or two) you are using on the controller modules.
Before you begin
• You must have met the system requirements.
Requirements for a hot-add
• You must have completed the applicable preparation procedures.
Prepare for a hot-add
1501
To Next Page
Loading...
Need help?
General
