Step Perform on each controller module
Cable the e0M ports to the management network switches with the RJ45 cables:
DO NOT plug in the power cords at this point.
2. To complete setting up your system, see
Step 4: Complete system setup and configuration.
Step 4: Complete system setup and configuration
Complete the system setup and configuration using cluster discovery with only a connection to the switch and
laptop, or by connecting directly to a controller in the system and then connecting to the management switch.
Option 1: Complete system setup and configuration if network discovery is enabled
If you have network discovery enabled on your laptop, you can complete system setup and configuration using
automatic cluster discovery.
Steps
1. Plug the power cords into the controller power supplies, and then connect them to power sources on
different circuits.
2. Turn on the power switches to both nodes.
Initial booting may take up to eight minutes..
3. Make sure that your laptop has network discovery enabled.
See your laptop’s online help for more information.
12
To Next Page
Loading...
