4. Use the animation (Connecting your laptop to the Management switch) to connect your laptop to the
Management switch.
5. Select an ONTAP icon listed to discover:
a. Open File Explorer.
b. Click Network in the left pane.
c. Right-click and select refresh.
d. Double-click either ONTAP icon and accept any certificates displayed on your screen.
XXXXX is the system serial number for the target node.
System Manager opens.
6. Use System Manager guided setup to configure your system using the data you collected in the ONTAP
Configuration Guide
.
7. Verify the health of your system by running Config Advisor.
8. After you have completed the initial configuration, go to the ONTAP & ONTAP System Manager
Documentation Resources
page for information about configuring additional features in ONTAP.
The default port configuration for Unified configuration systems is CNA mode; if connecting
to an FC host network, you have to modify the ports for FC mode.
Option 2: Complete system setup and configuration if network discovery is not enabled
If network discovery is not enabled on your laptop, you must complete the configuration and setup using this
task.
1. Cable and configure your laptop or console:
a. Set the console port on the laptop or console to 115,200 baud with N-8-1.
See your laptop or console’s online help for how to configure the console port.
13
To Next Page
Loading...
