NetApp CN1610 - Outbound Telnet

Chapter 2: Switch Administration 39
Outbound Telnet
Feature overview You can establish an outbound Telnet connection between the switch and a
remote host. When a Telnet connection is initiated, each side of the connection is
assumed to originate and terminate at a Network Virtual Terminal (NVT).
Configuration
example
The following example connects from this switch to a remote switch and the
remote switch’s CLI to view data:
(CN1610) #telnet 192.168.77.151
Trying 192.168.77.151...
(CN1610) #
User:admin
Password:
(switch) >enable
Password:
(CN1610) #show network
Interface Status............................... Always Up
IP Address..................................... 10.250.3.1
Subnet Mask.................................... 255.255.255.0
Default Gateway................................ 10.250.3.3
IPv6 Administrative Mode....................... Enabled
IPv6 Prefix is ................................
fe80::210:18ff:fe82:64c/64
IPv6 Prefix is ................................ 2003::1/128
IPv6 Default Router is ........................
fe80::204:76ff:fe73:423a
Burned In MAC Address.......................... 00:10:18:82:06:4C
Locally Administered MAC address............... 00:00:00:00:00:00
MAC Address Type............................... Burned In
Configured IPv4 Protocol ...................... None
Configured IPv6 Protocol ...................... DHCP
DHCPv6 Client DUID ............................
00:03:00:06:00:10:18:82:06:4C
IPv6 Autoconfig Mode........................... Disabled
Management VLAN ID............................. 1