NetApp CN1610 - User Manual

NetApp® CN1610 Network Switch
CLI Command Reference
NetApp, Inc.
495 East Java
Drive
Sunnyvale, CA 94089 U.S.A.
Telephone: +1 (408) 822-6000
Fax: +1 (408) 822-4501
Support telephone: +1 (888) 463-8277
Documentation comments: doccomments@netapp.com
Information Web: www.netapp.com
Part number: 215-06286_C0
August 2017

NetApp CN1610 Specifications

General

Ports	16 x 10GbE SFP+
Form Factor	1U
Management	CLI, SNMP, Web GUI
Latency	600ns
Compatibility	NetApp storage systems
Power Supply	Dual redundant power supplies

Summary

Using the Command-Line Interface

Command Syntax

Explains the structure of commands, including keywords, required and optional parameters.

Using CLI Help

Management Commands

Network Interface Commands

Covers commands for configuring logical interfaces for management access, including IP settings.

User Account Commands

Utility Commands

System Information and Statistics Commands

System Utility and Clear Commands

Commands for troubleshooting connectivity and restoring configurations to factory defaults.

Serviceability Packet Tracing Commands

Switching Commands

Port Configuration Commands

Describes commands for viewing and configuring switch port settings like mode, auto-negotiation, and MTU.

Spanning Tree Protocol Commands

Details commands for configuring Spanning Tree Protocol (STP) to prevent network loops.

VLAN Commands

Describes commands for configuring VLAN settings, including creation, deletion, and participation.

Port Security Commands

Commands to configure and view protected ports, allowing MAC address locking on a given port.

Port-Channel;LAG (802.3 ad) Commands

Quality of Service Commands

Class of Service Commands

DiffServ Class Commands

Defines traffic classification by specifying Behavior Aggregate (BA) and match criteria.

MAC Access Control List Commands

IP Access Control List Commands