NetApp CN1610 - Show Dhcp L2 Relay Circuit-ID Vlan; Show Dhcp L2 Relay Interface; Show Dhcp L2 Relay Remote-ID Vlan

Chapter 5: Switching Commands 481
8 Enabled Disabled --NULL--
9 Enabled Disabled --NULL--
10 Enabled Disabled --NULL--
show dhcp l2relay
circuit-id vlan
This command displays DHCP circuit-id vlan configuration.
show dhcp l2relay
interface
This command displays DHCP L2 relay configuration specific to interfaces.
The following shows example CLI display output for the command.
(Broadcom FASTPATH Switching) #show dhcp l2relay interface all
DHCP L2 Relay is Enabled.
Interface L2RelayMode TrustMode
---------- ----------- --------------
0/2 Enabled untrusted
0/4 Disabled trusted
show dhcp l2relay
remote-id vlan
This command displays DHCP Remote-id vlan configuration.
Format
show dhcp l2relay circuit-id vlan vlan-list
Mode Privileged EXEC
Parameter Description
vlan-list Enter VLAN IDs in the range 1–4093. Use a dash (–
) to specify a range or a comma (,) to separate
VLAN IDs in a list. Spaces and zeros are not
permitted.
Format
show dhcp l2relay interface {all | interface-num }
Mode Privileged EXEC
Format
show dhcp l2relay remote-id vlan vlan-list
Mode Privileged EXEC