598 IPv6 Management Commands
no network ipv6
address
The command no network ipv6 address removes all configured IPv6 prefixes.
Use this command with the address option to remove the manually configured
IPv6 global address on the network port interface.
Use this command with the autoconfig option to disable the stateless global
address autoconfiguration on the network port.
Use this command with the dhcp option disables the dhcpv6 client protocol on
the network port.
network ipv6
gateway
Use this command to configure IPv6 gateway (i.e. default routers) information
for the network port.
no network ipv6
gateway
Use this command to remove IPv6 gateways on the network port interface.
autoconfig Configure stateless global address autoconfiguration
capability.
dhcp Configure dhcpv6 client protocol.
Parameter Description
Format
no network ipv6 address {
address/prefix-length
[eui64] | autoconfig | dhcp}
Mode Privileged EXEC
Format
network ipv6 gateway
gateway-address
Mode Privileged EXEC
Parameter Description
gateway-address Gateway address in IPv6 global or link-local address
format.
To Next Page
Loading...
