Chapter 5: Switching Commands 591
The following shows example CLI display output for the command.
(CN1610) #show isdp traffic
ISDP Packets Received.......................... 4253
ISDP Packets Transmitted....................... 127
ISDPv1 Packets Received........................ 0
ISDPv1 Packets Transmitted..................... 0
ISDPv2 Packets Received........................ 4253
ISDPv2 Packets Transmitted..................... 4351
ISDP Bad Header................................ 0
ISDP Checksum Error............................ 0
ISDP Transmission Failure...................... 0
ISDP Invalid Format............................ 0
ISDP Table Full................................ 392
ISDP IP Address Table Full..................... 737
debug isdp packet This command enables tracing of ISDP packets processed by the switch. ISDP
must be enabled on both the device and the interface in order to monitor packets
for a particular interface.
ISDP Bad Header Number of packets received with a bad header
ISDP Checksum Error Number of packets received with a checksum error
ISDP Transmission
Failure
Number of packets which failed to transmit
ISDP Invalid Format Number of invalid packets received
ISDP Table Full Number of times a neighbor entry was not added to
the table due to a full database
ISDP IP Address
Table Full
Displays the number of times a neighbor entry was
added to the table without an IP address.
Term Definition
Format
debug isdp packet [{receive | transmit}]
Mode Privileged EXEC
To Next Page
Loading...
