NetApp CN1610 - No Sntp Unicast Client Poll-Timeout; Sntp Unicast Client Poll-Retry; No Sntp Unicast Client Poll-Retry; Sntp Server

Chapter 4: Utility Commands 227
no sntp unicast
client poll-timeout
This command will reset the poll timeout for SNTP unicast clients to its default
value.
sntp unicast client
poll-retry
This command will set the poll retry for SNTP unicast clients to a value from 0 to
10.
no sntp unicast
client poll-retry
This command will reset the poll retry for SNTP unicast clients to its default
value.
sntp server This command configures an SNTP server (a maximum of three). The server
address can be either an IPv4 address or an IPv6 address. The optional priority
can be a value of 1-3, the version a value of 1-4, and the port id a value of 1-
65535.
Format
sntp unicast client poll-timeout poll-timeout
Mode Global Config
Format
no sntp unicast client poll-timeout
Mode Global Config
Default 1
Format
sntp unicast client poll-retry poll-retry
Mode Global Config
Format
no sntp unicast client poll-retry
Mode Global Config
Format
sntp server { ipaddress | ipv6address | hostname }
[
priority [ version [ portid ]]]
Mode Global Config