NetApp CN1610 - No Snmp-Server Enable Traps; Snmp Trap Link-Status; No Snmp Trap Link-Status; Snmp Trap Link-Status All

92 SNMP Commands
no snmp-server
enable traps
This command disables the Authentication Flag.
snmp trap link-
status
This command enables link status traps on an interface or range of interfaces.
Note
This command is valid only when the Link Up/Down Flag is enabled. See “snmp
trap link-status” on page 92
no snmp trap link-
status
This command disables link status traps by interface.
Note
This command is valid only when the Link Up/Down Flag is enabled.
snmp trap link-
status all
This command enables link status traps for all interfaces.
Note
This command is valid only when the Link Up/Down Flag is enabled. See “snmp
trap link-status” on page 92.
Mode Global Config
Format
no snmp-server enable traps
Mode Global Config
Format
snmp trap link-status
Mode Interface Config
Format
no snmp trap link-status
Mode Interface Config
Format
snmp trap link-status all
Mode Global Config