NetApp CN1610 - Ipv6 Management Commands; Serviceport Ipv6 Enable; No Serviceport Ipv6 Enable; Network Ipv6 Enable

594 IPv6 Management Commands
IPv6 Management Commands
IPv6 Management commands allow a device to be managed via an IPv6 address
in a switch or IPv4 routing (i.e., independent from the IPv6 Routing package).
For Routing/IPv6 builds of FASTPATH dual IPv4/IPv6 operation over the service
port is enabled. FASTPATH has capabilities such as:
◆ Static assignment of IPv6 addresses and gateways for the service/network
ports.
◆ The ability to ping an IPv6 link-local address over the service/network port.
◆ Using IPv6 Management commands, you can send SNMP traps and queries
via the service/network port.
◆ The user can manage a device via the network port (in addition to a Routing
Interface or the Service port).
serviceport ipv6
enable
Use this command to enable IPv6 operation on the service port. By default, IPv6
operation is enabled on the service port.
no serviceport ipv6
enable
Use this command to disable IPv6 operation on the service port.
network ipv6 enable Use this command to enable IPv6 operation on the network port. By default, IPv6
operation is enabled on the network port.
Default enabled
Format
serviceport ipv6 enable
Mode Privileged EXEC
Format
no serviceport ipv6 enable
Mode Privileged EXEC
Default enabled
Format
network ipv6 enable
Mode Privileged EXEC