Chapter 3: Management Commands 29
3
Management Commands
This chapter describes the management commands available in the FASTPATH
CLI.
The Management Commands chapter contains the following sections:
◆ “Network Interface Commands” on page 30
◆ “Console Port Access Commands” on page 38
◆ “Telnet Commands” on page 41
◆ “Secure Shell Commands” on page 47
◆ “Management Security Commands” on page 50
◆ “Access Commands” on page 51
◆ “User Account Commands” on page 53
◆ “SNMP Commands” on page 89
◆ “RADIUS Commands” on page 107
◆ “TACACS+ Commands” on page 125
◆ “Configuration Scripting Commands” on page 130
◆ “Prelogin Banner, System Prompt, and Host Name Commands” on page 133
The commands in this chapter are in one of three functional groups:
◆ Show commands display switch settings, statistics, and other information.
◆ Configuration commands configure features and options of the switch. For
every configuration command, there is a
show
command that displays the
configuration setting.
◆ Clear commands clear some or all of the settings to factory defaults.
To Next Page
