NetApp CN1610 - Copy

Chapter 4: Utility Commands 219
copy The copy command uploads and downloads files to and from the switch. You can
also use the
copy command to manage the dual images (active and backup) on
the file system. Upload and download files from a server using FTP, TFTP,
Xmodem, Ymodem, or Zmodem. SFTP and SCP are available as additional
transfer methods if the software package supports secure management. If FTP is
used, a password is required.
Replace the
source and destination parameters with the desired options. For
the
url source or destination, use one of the following values:
{xmodem | tftp:// ipaddr | hostname |
ip6address | hostname/filepath/filename [noval]|
sftp|scp://
username@ipaddr | ipv6address/filepath / filename |
ftp://
user@ipaddress | hostname/filepath/filename }
verify | noverify is only available if the image/configuration verify options
feature is enabled (see “write memory” on page 224).
verify specifies that
digital signature verification will be performed for the specified downloaded
image or configuration file.
noverify specifies that no verification will be
performed.
The keyword ias-users supports the downloading of the IAS user database file.
When the IAS users file is downloaded, the switch IAS user’s database is
replaced with the users and its attributes available in the downloaded file. In the
command copy url ias-users, for url one of the following is used for IAS users
file:
{ { tftp://<ipaddr | hostname> | <ipv6address | hostname> /<filepath>/<filename>
} | { sftp | scp://<username>@<ipaddress>/<filepath>/<filename>} }
Note
The maximum length for the file path is 160 characters, and the maximum length
for the file name is 31 characters.
Mode Privileged EXEC
Format
copy source destination {verify | noverify}
Mode Privileged EXEC