Chapter 3: Management Commands 43
session-limit This command specifies the maximum number of simultaneous outbound Telnet
sessions. A value of 0 indicates that no outbound Telnet session can be
established.
no session-limit This command sets the maximum number of simultaneous outbound Telnet
sessions to the default value.
session-timeout This command sets the Telnet session timeout value.The timeout value unit of
time is minutes.
no session-timeout This command sets the Telnet session timeout value to the default. The timeout
value unit of time is minutes.
telnetcon
maxsessions
This command specifies the maximum number of Telnet connection sessions that
can be established. A value of 0 indicates that no Telnet connection can be
established. The range is 0-5.
Default 5
Format
session-limit
0-5
Mode Line Config
Format
no session-limit
Mode Line Config
Default 5
Format
session-timeout
1-160
Mode Line Config
Format
no session-timeout
Mode Line Config
Default 5
To Next Page
Loading...
