NetApp CN1610 - No Password (Line Configuration)

70 User Account Commands
The following example specifies a password mcmxxyyy on a line.
(CN1610)(config-line)# password mcmxxyyy
The following is another example of the command.
(Switching)(Config-line)# password testtest
(Switching) (Config-line)# password
e8d63677741431114f9e39a853a15e8fd35ad059e2e1b49816c243d7e08152b052
eafbf23b528d348cdba1b1b7ab91be842278e5e970dbfc62d16dcd13c0b864
encrypted
(Switching) (Config-line)# password
Enter new password:********
Confirm new password:********
no password (Line
Configuration)
Use this command to remove the password on a line.
Format
password [password [encrypted]]
Mode Line Config
Parameter Definition
password Password for this level. Range: 8-64 characters
encrypted Encrypted password to be entered, copied from
another switch configuration. The encrypted
password should be 128 characters long because the
assumption is that this password is already
encrypted with AES.
Format
no password
Mode Line Config