436 Storm-Control Commands
no storm-control
multicast
This command disables multicast storm recovery mode for all interfaces (Global
Config mode) or one or more interfaces (Interface Config mode).
storm-control
multicast level
This command configures the multicast storm recovery threshold for all
interfaces (Global Config mode) or one or more interfaces (Interface Config
mode) as a percentage of link speed and enables multicast storm recovery mode.
If the mode is enabled, multicast storm recovery is active, and if the rate of L2
multicast traffic ingressing on an interface increases beyond the configured
threshold, the traffic will be dropped. Therefore, the rate of multicast traffic will
be limited to the configured threshold.
no storm-control
multicast level
This command sets the multicast storm recovery threshold to the default value for
all interfaces (Global Config mode) or one or more interfaces (Interface Config
mode) and disables multicast storm recovery.
Format
storm-control multicast
Mode ◆ Global Config
◆ Interface Config
Format
no storm-control multicast
Mode ◆ Global Config
◆ Interface Config
Default 5
Format
storm-control multicast level
0-100
Mode ◆ Global Config
◆ Interface Config
Format
no storm-control multicast level
0-100
Mode ◆ Global Config
◆ Interface Config
To Next Page
Loading...
