NetApp CN1610 - Logging Commands; Logging Buffered; No Logging Buffered; Logging Buffered Wrap;No Logging Buffered Wrap

Chapter 4: Utility Commands 193
Logging Commands
This section describes the commands you use to configure system logging, and to
view logs and the logging settings.
logging buffered This command enables logging to an in-memory log.
no logging buffered This command disables logging to in-memory log.
logging buffered
wrap
This command enables wrapping of in-memory logging when the log file reaches
full capacity. Otherwise when the log file reaches full capacity, logging stops.
no logging buffered
wrap
This command disables wrapping of in-memory logging and configures logging
to stop when the log file capacity is full.
Default disabled; critical when enabled
Format
logging buffered
Mode Global Config
Format
no logging buffered
Mode Global Config
Default enabled
Format
logging buffered wrap
Mode Privileged EXEC
Format
no logging buffered wrap
Mode Privileged EXEC