NetApp CN1610 - Network Ipv6 Neighbor; No Network Ipv6 Neighbor; Show Network Ipv6 Neighbor

Chapter 6: IPv6 IPv6 Management Commands 599
network ipv6
neighbor
Use this command to manually add IPv6 neighbors to the IPv6 neighbor table for
this network port. If an IPv6 neighbor already exists in the neighbor table, the
entry is automatically converted to a static entry. Static entries are not modified
by the neighbor discovery process. They are, however, treated the same for IPv6
forwarding. Static IPv6 neighbor entries are applied to the kernel stack and to the
hardware when the corresponding interface is operationally active.
no network ipv6
neighbor
Use this command to remove IPv6 neighbors from the neighbor table.
show network ipv6
neighbors
Use this command to display the information about the IPv6 neighbor entries
cached on the network port. The information is updated to show the type of the
entry.
Format
no network ipv6 gateway
Mode Privileged EXEC
Format
network ipv6 neighbor ipv6-address macaddr
Mode Privileged EXEC
Parameter Description
ipv6-address The IPv6 address of the neighbor or interface.
macaddr The link-layer address.
Format
no network ipv6 neighbor ipv6-address macaddr
Mode Privileged EXEC
Default None
Format
show network ipv6 neighbors
Mode ◆ Privileged EXEC