644 DiffServ Show Commands
(CN1610) #show policy-map p1
Policy Name.................................... p1
Policy Type.................................... In
Class Name..................................... c1
Mark CoS as Secondary CoS...................... Yes
The following shows example CLI display output including the mark-cos-as-sec-
cos action used in the policing (simple-police, police-single-rate, police two-rate)
command.
(CN1610) #show policy-map p2
Policy Name....................... p2
Policy Type....................... In
Class Name........................ c2
Policing Style.................... Police Two Rate
Committed Rate.................... 1
Committed Burst Size.............. 1
Peak Rate......................... 1
Peak Burst Size................... 1
Conform Action.................... Mark CoS as Secondary CoS
Exceed Action..................... Mark CoS as Secondary CoS
Non-Conform Action................ Mark CoS as Secondary CoS
Conform Color Mode................ Blind
Exceed Color Mode................. Blind
show diffserv
service
This command displays policy service information for the specified interface and
direction. The slot/port
parameter specifies a valid slot/port number for the
system.
Format
show diffserv service slot/port
in
Mode Privileged EXEC
Term Definition
DiffServ Admin
Mode
The current setting of the DiffServ administrative
mode. An attached policy is only in effect on an
interface while DiffServ is in an enabled mode.
Interface slot/port
Direction The traffic direction of this interface service.
To Next Page
Loading...
