NetApp CN1610 - Acl-Trapflags; No Acl-Trapflags; Show Ip Access-Lists

670 IP Access Control List Commands
The following shows an example of the command.
(CN1610)(Config)#no ip access-group ip1 control-plane
acl-trapflags
This command enables the ACL trap mode.
no acl-trapflags
This command disables the ACL trap mode.
show ip access-lists Use this command to view summary information about all IP ACLs configured
on the switch. To view more detailed information about a specific access list,
specify the ACL number or name that is used to identify the IP ACL. The rate-
limit attribute displays committed rate and committed burst size.
Mode
◆ Interface Config
◆ Global Config
Default disabled
Format
acl-trapflags
Mode Global Config
Format
no acl-trapflags
Mode Global Config
Format
show ip access-lists [ accesslistnumber | name ]
Mode Privileged EXEC
Term Definition
ACL ID/Name Identifies the configured ACL number or name.
Rules Identifies the number of rules configured for the
ACL.