Chapter 6: IPv6 IPv6 Management Commands 597
neighbor discovery process. They are, however, treated the same for IPv6
forwarding. Static IPv6 neighbor entries are applied to the kernel stack and to the
hardware when the corresponding interface is operationally active.
no serviceport ipv6
neighbor
Use this command to remove IPv6 neighbors from the IPv6 neighbor table for the
service port.
network ipv6
address
Use the options of this command to manually configure IPv6 global address,
enable/disable stateless global address autoconfiguration and to enable/disable
dhcpv6 client protocol information for the network port. Multiple IPv6 addresses
can be configured on the network port.
Format
serviceport ipv6 neighbor
ipv6-address macaddr
Mode Privileged EXEC
Parameter Description
ipv6-address The IPv6 address of the neighbor or interface.
macaddr The link-layer address.
Format
no serviceport ipv6 neighbor
ipv6-address macaddr
Mode Privileged EXEC
Format
network ipv6 address {
address/prefix-length
[eui64]
| autoconfig | dhcp}
Mode Privileged EXEC
Parameter Description
address IPv6 prefix in IPv6 global address format.
prefix-length IPv6 prefix length value.
eui64 Formulate IPv6 address in eui64 format.
To Next Page
Loading...
