NetApp CN1610 - Lldp Med Transmit-Tlv; No Lldp Med Transmit-Tlv; Lldp Med All

558 LLDP-MED Commands
lldp med transmit-
tlv
Use this command to specify which optional Type Length Values (TLVs) in the
LLDP MED set will be transmitted in the Link Layer Discovery Protocol Data
Units (LLDPDUs) from this interface or a range of interfaces.
no lldp med
transmit-tlv
Use this command to remove a TLV.
lldp med all
Use this command to configure LLDP-MED on all the ports.
Default By default, the capabilities and network policy TLVs are included.
Format
lldp med transmit-tlv [capabilities] [ex-pd] [ex-pse]
[inventory] [location] [network-policy]
Mode Interface Config
Term Definition
capabilities Transmit the LLDP capabilities TLV.
ex-pd Transmit the LLDP extended PD TLV.
ex-pse Transmit the LLDP extended PSE TLV.
inventory Transmit the LLDP inventory TLV.
location Transmit the LLDP location TLV.
network-policy Transmit the LLDP network policy TLV.
Format
no lldp med transmit-tlv [capabilities] [network-
policy] [ex-pse] [ex-pd] [location] [inventory]
Mode Interface Config
Format
lldp med all
Mode Global Config