Chapter 3: Management Commands 31
serviceport ip This command sets the IP address, the netmask and the gateway of the network
management port. You can specify the
none
option to clear the IPv4 address and
mask and the default gateway (i.e., reset each of these values to 0.0.0.0).
serviceport
protocol
This command specifies the network management port configuration protocol. If
you modify this value, the change is effective immediately. If you use the
bootp
parameter, the switch periodically sends requests to a BootP server until a
response is received. If you use the
dhcp parameter, the switch periodically sends
requests to a DHCP server until a response is received. If you use the
none
parameter, you must configure the network information for the switch manually.
serviceport
protocol dhcp
This command enables the DHCPv4 client on a Service port.
The following shows an example of the command.
(CN1610) # serviceport protocol dhcp
network parms This command sets the IP address, subnet mask and gateway of the device. The
IP address and the gateway must be on the same subnet. When you specify the
none
option, the IP address and subnet mask are set to the factory defaults.
Format
serviceport ip {
ipaddr netmask
[
gateway
] | none}
Mode Privileged EXEC
Format
serviceport protocol {none | bootp | dhcp}
Mode Privileged EXEC
Default none
Format
serviceport protocol dhcp
Mode Privileged EXEC
Format
network parms {
ipaddr netmask
[
gateway
]| none}
Mode Privileged EXEC
To Next Page
Loading...
