Chapter 5: Switching Commands 589
show isdp
neighbors
This command displays the list of neighboring devices.
The following shows example CLI display output for the command.
(CN1610) #show isdp neighbors
Capability Codes: R - Router, T - Trans Bridge, B - Source Route
Bridge,
S - Switch, H - Host, I - IGMP, r - Repeater
Device ID Intf Holdtime Capability Platform Port
ID
-------------------- ----- --------- ------------ -----------------
--- --------------------
Format
show isdp neighbors [{slot/port
| detail}]
Mode Privileged EXEC
Term Definition
Device ID The device ID associated with the neighbor which
advertised the information.
IP Addresses The IP addresses associated with the neighbor.
Capability ISDP functional capabilities advertised by the
neighbor.
Platform The hardware platform advertised by the neighbor.
Interface The interface (slot/port) on which the neighbor's
advertisement was received.
Port ID The port ID of the interface from which the neighbor
sent the advertisement.
Hold Time The hold time advertised by the neighbor.
Advertisement
Vers io n
The version of the advertisement packet received
from the neighbor.
Entry Last Changed
Time
Time when the entry was last modified.
Version The software version that the neighbor is running.
To Next Page
Loading...
