NetApp CN1610 - Show Rmon Collection History

Chapter 4: Utility Commands 293
Last Sample Value: 1
Interval: 1
Sample Type: absolute
Startup Alarm: rising-falling
Rising Threshold: 1
Falling Threshold: 1
Rising Event: 1
Falling Event: 2
Owner: MibBrowser
show rmon
collection history
This command displays the entries in the RMON history control table.
The following shows example CLI display output for the command.
Format
show rmon collection history [interfaces slot/port]
Mode Privileged EXEC
Parameter Description
History Control Index An index that uniquely identifies an entry in the
historyControl table. Each such entry defines a set of
samples at a particular interval for an interface on
the device. The range is 1 to 65535.
History Control Data
Source
The source interface for which historical data is
collected.
History Control
Buckets Requested
The requested number of discrete time intervals over
which data is to be saved. The range is 1 to 65535.
The default is 50.
History Control
Buckets Granted
The number of discrete sampling intervals over
which data shall be saved. This object is read-only.
The default is 10.
History Control
Interval
The interval in seconds over which the data is
sampled. The range is 1 to 3600. The default is
1800.
History Control
Owner
The owner string associated with the history control
entry. The default is monitorHistoryControl.