NetApp CN1610 - Dot1 X Max-Req; No Dot1 X Max-Req; Dot1 X Max-Users; No Dot1 X Max-Users

404 Port-Based Network Access Control Commands
dot1x max-req This command sets the maximum number of times the authenticator state
machine on an interface or range of interfaces will transmit an EAPOL EAP
Request/Identity frame before timing out the supplicant. The
count value must
be in the range 1 - 10.
no dot1x max-req This command sets the maximum number of times the authenticator state
machine on this port will transmit an EAPOL EAP Request/Identity frame before
timing out the supplicant.
dot1x max-users Use this command to set the maximum number of clients supported on an
interface or range of interfaces when MAC-based dot1x authentication is enabled
on the port. The maximum users supported per port is dependent on the product.
The
count value is in the range 1 - 48.
no dot1x max-users This command resets the maximum number of clients allowed per port to its
default value.
Default 2
Format
dot1x max-req count
Mode Interface Config
Format
no dot1x max-req
Mode Interface Config
Default 48
Format
dot1x max-users count
Mode Interface Config
Format
no dot1x max-users
Mode Interface Config