Chapter 7: Quality of Service Commands 637
no service-policy This command detaches a policy from an interface in the inbound direction as
indicated by the
in
parameter, or the outbound direction as indicated by the
out
parameter, respectively. The
policyname parameter is the name of an existing
DiffServ policy.
This command causes a service to remove its reference to the policy. This
command effectively disables DiffServ on an interface in the inbound direction
or an interface in the outbound direction. There is no separate interface
administrative 'mode' command for DiffServ.
Format
no service-policy {in|out}
policymapname
Modes ◆ Global Config
◆ Interface Config
To Next Page
Loading...
