NetApp CN1610 - Capture Remote Port; Capture File Size; Capture Line Wrap;No Capture Line Wrap; Show Capture Packets

Chapter 4: Utility Commands 247
capture remote port Use this command to configure file capture options. The command is persistent
across a reboot cycle. The
id parameter is a TCP port number from 1024–
49151.
capture file size Use this command to configure file capture options. The command is persistent
across a reboot cycle. The
max-file-size parameter is the maximum size the
pcap file can reach, which is 2–512 KB.
capture line wrap This command enables wrapping of captured packets in line mode when the
captured packets reaches full capacity.
no capture line
wrap
This command disables wrapping of captured packets and configures capture
packet to stop when the captured packet capacity is full.
show capture
packets
Use this command to display packets captured and saved to RAM. It is possible
to capture and save into RAM, packets that are received or transmitted through
the CPU. A maximum 128 packets can be saved into RAM per capturing session.
A maximum 128 bytes per packet can be saved into the RAM. If a packet holds
more than 128 bytes, only the first 128 bytes are saved; data more than 128 bytes
is skipped and cannot be displayed in the CLI.
Format
capture remote port id
Mode Global Config
Format
capture file size max file size
Mode Global Config
Format
capture line wrap
Mode Global Config
Format
no capture line wrap
Mode Global Config