NetApp CN1610 - Spanning-Tree Max-Age; No Spanning-Tree Max-Age; Spanning-Tree Max-Hops;No Spanning-Tree Max-Hops; Spanning-Tree Mode

326 Spanning Tree Protocol Commands
spanning-tree max-
age
This command sets the Bridge Max Age parameter to a new value for the
common and internal spanning tree. The max-age value is in seconds within a
range of 6 to 40, with the value being less than or equal to 2 x (Bridge Forward
Delay - 1).
no spanning-tree
max-age
This command sets the Bridge Max Age parameter for the common and internal
spanning tree to the default value.
spanning-tree max-
hops
This command sets the Bridge Max Hops parameter to a new value for the
common and internal spanning tree. The max-hops value is a range from 6 to 40.
no spanning-tree
max-hops
This command sets the Bridge Max Hops parameter for the common and internal
spanning tree to the default value.
spanning-tree mode This command configures global spanning tree mode per VLAN spanning tree.
On a switch, only one mode can be enabled at a time.
Default 20
Format
spanning-tree max-age 6-40
Mode Global Config
Format
no spanning-tree max-age
Mode Global Config
Default 20
Format
spanning-tree max-hops 6-40
Mode Global Config
Format
no spanning-tree max-hops
Mode Global Config