Chapter 5: Switching Commands 501
no ip arp inspection
trust
Use this command to configure an interface as untrusted for Dynamic ARP
Inspection.
ip arp inspection
limit
Use this command to configure the rate limit and burst interval values for an
interface or range of interfaces. Configuring
none
for the limit means the
interface is not rate limited for Dynamic ARP Inspections. The maximum pps
value shown in the range for the rate option might be more than the hardware
allowable limit. Therefore you need to understand the switch performance and
configure the maximum rate pps accordingly.
The user interface will accept a rate limit for a trusted interface, but the limit will
not be enforced unless the interface is configured to be untrusted.
no ip arp inspection
limit
Use this command to set the rate limit and burst interval values for an interface to
the default values of 15 pps and 1 second, respectively.
Mode Interface Config
Format
no ip arp inspection trust
Mode Interface Config
Default
15 pps for rate and 1 second for burst-interval
Format
ip arp inspection limit {rate pps [burst interval
seconds] | none}
Mode Interface Config
Format
no ip arp inspection limit
Mode Interface Config
To Next Page
Loading...
