NetApp CN1610 - No Set Garp Timer Leave; Set Garp Timer Leaveall

392 GARP Commands
maintain uninterrupted service. The leave time is 20 to 600 (centiseconds). The
value 60 centiseconds is 0.6 seconds. The leave time must be greater than or
equal to three times the join time.
no set garp timer
leave
This command sets the GVRP leave time on all ports or a single port to the
default and only has an effect when GVRP is enabled.
set garp timer
leaveall
This command sets how frequently Leave All PDUs are generated. A Leave All
PDU indicates that all registrations will be unregistered. Participants would need
to rejoin in order to maintain registration. The value applies per port and per
GARP participation. The time may range from 200 to 6000 (centiseconds). The
value 1000 centiseconds is 10 seconds. You can use this command on all ports
(Global Config mode), or on a single port or a range of ports (Interface Config
mode) and it only has an effect only when GVRP is enabled. The leave all time
must be greater than the leave time.
Default 60
Format
set garp timer leave 20-600
Mode ◆ Interface Config
◆ Global Config
Format
no set garp timer leave
Mode ◆ Interface Config
◆ Global Config
Default 1000
Format
set garp timer leaveall 200-6000
Mode ◆ Interface Config
◆ Global Config