NetApp CN1610 - Show Igmpsnooping Mrouter Vlan; Show Igmpsnooping Ssm

Chapter 5: Switching Commands 517
The following shows example CLI display output for the command.
(Broadcom FASTPATH Switching) #show igmpsnooping 1
VLAN ID........................................ 1
IGMP Snooping Admin Mode....................... Disabled
Fast Leave Mode................................ Disabled
Group Membership Interval (secs)............... 260
Max Response Time (secs)....................... 10
Multicast Router Expiry Time (secs)............ 0
Report Suppression Mode........................ Enabled
show
igmpsnooping
mrouter vlan
This command displays information about statically configured ports.
show
igmpsnooping ssm
This command displays information about Source Specific Multicasting (SSM)
by entry, group, or statistics. SSM delivers multicast packets to receivers that
originated from a source address specified by the receiver. SSM is only available
with IGMPv3 and MLDv2.
Report Suppression
Mode
Indicates whether IGMP reports (set by the
command “set igmp report-suppression” on
page 514) in enabled or not.
Term Definition
Format
show igmpsnooping mrouter vlan slot/port
Mode Privileged EXEC
Term Definition
Interface The port on which multicast router information is
being displayed.
VLAN ID The list of VLANs of which the interface is a
member.
Format
show igmpsnooping ssm {entries | groups | stats}