NetApp CN1610 - Show Spanning-Tree Mst Port Detailed

Chapter 5: Switching Commands 341
Designated Root................................
80:00:00:10:18:48:FC:07
Root Path Cost................................. 0
Root Port Identifier........................... 00:00
Associated FIDs Associated VLANs
--------------- ----------------
(CN1610) >
show spanning-tree
mst port detailed
This command displays the detailed settings and parameters for a specific switch
port within a particular multiple spanning tree instance. The parameter
mstid is
a number that corresponds to the desired existing multiple spanning tree instance.
The slot/port is the desired switch port. Instead of slot/port
, lag lag-intf-num
can be used as an alternate way to specify the LAG interface.
lag lag-intf-num
can also be used to specify the LAG interface where
lag-intf-num is the LAG
port number.
Format
show spanning-tree mst port detailed mstid
{
slot/port | lag lag-intf-num}
Mode ◆ Privileged EXEC
◆ User EXEC
Term Definition
MST Instance ID The ID of the existing multiple spanning tree (MST)
instance identifier. The value is 0–4094.
Port Identifier The port identifier for the specified port within the
selected MST instance. It is made up from the port
priority and the interface number of the port.
Port Priority The priority for a particular port within the selected
MST instance. The port priority is displayed in
multiples of 16.
Port Forwarding State Current spanning tree state of this port.