Chapter 5: Switching Commands 527
no set
groupmembership-
interval
Use this command to set the MLDv2 Group Membership Interval time to the
default value.
set mld
maxresponse
Use this command to set the MLD Maximum Response time for the system, on a
particular interface or VLAN. The Maximum Response time is the amount of
time in seconds that a switch will wait after sending a query on an interface
because it did not receive a report for a particular group in that interface. This
value must be less than the MLD Query Interval time value. The range is 1 to 65
seconds.
no set mld
maxresponse
Use this command to set the max response time (on the interface or VLAN) to the
default value.
Format
set mld groupmembership-interval
vlanid 2-3600
Mode ◆ Interface Config
◆ Global Config
◆ VLAN Mode
Format
no set mld groupmembership-interval
Mode ◆ Interface Config
◆ Global Config
◆ VLAN Mode
Default 10 seconds
Format
set mld maxresponse
1-65
Mode ◆ Global Config
◆ Interface Config
◆ VLAN Mode
Format
no set mld maxresponse
To Next Page
Loading...
