NetApp CN1610 - IP Access Control List Commands

652 MAC Access Control List Commands
The following shows an example of the command.
(CN1610)(Config)#mac access-group mac1 control-plane
no mac access-
group
This command removes a MAC ACL identified by name from the interface in a
given direction.
The following shows an example of the command.
(CN1610)(Config)#no mac access-group mac1 control-plane
show mac access-
lists
This command displays a MAC access list and all of the rules that are defined for
the MAC ACL. Use the
[name] parameter to identify a specific MAC ACL to
display. The
rate-limit attribute displays committed rate and committed burst
size.
Note
The command output varies based on the match criteria configured within the
rules of an ACL.
Format
mac access-group name {{ control-plane| in|out} vlan
vlan-id {in|out}}
Modes ◆ Global Config
◆ Interface Config
Parameter Description
name The name of the Access Control List.
vlan-id A VLAN ID associated with a specific IP ACL in a
given direction.
Format
no mac access-group name {{ control-plane| in|out} vlan
vlan-id {in|out}}
Modes ◆ Global Config
◆ Interface Config